SmartWAV2-MidiMode_R4

SMARTWAV 2

MIDI Mode

Program Change command is the second most important in a MIDI

system, basically those contain the next parameters:

-Command Type (Program Change)

-MIDI Channel (1-16)

-Program/Patch Number (0-127)

SmartWAV2 can change folders based on the received Program /

Patch Number if the folder names are created in the next manners:

-Program/Patch Number 0 refers to a folder named “000”.

-Program/Patch Number 64 refers to a folder named “064”.

-Program/Patch Number 127 refers to a folder named “127”.

Please check that the folder name is 3 chars long (filled with zeros).

Once SmartWAV2 starts and Program Change commands are

received, it will change or jump (go inside, go outside) folders that are

inside the master folder, this master folder path is fixed during system

run and normally/by default it is the root path (Refer to master folder

in section SmartWAV2 MIDIConfig.txt file).

The next image shows an example of a microSD card “root path”

contents, the patch/folder numbers 0, 64 and 127 in the correct

number naming structure: