SmartWAV2-MidiMode_R4

SMARTWAV 2
MIDI Mode
Vizic Technologies ©2020 | 23
5.7 Pitch Bend Change
This command modifies the sound of the playing notes/tracks by
changing the pitch from -2 to +2 half tones depending on the
received pitch parameter.
5.8 System Common Messages
System common messages are not musical commands; those refer to
basic control/configurations for a MIDI system. The next table shows
all the MIDI system common messages, the ones in bold black are the
ones that SmartWAV2 support, all other commands are ignored:
Command(hex)
Function
0xF0
Start Of System Exclusive Message
0xF1
MIDI Time code Quarter Frame
0xF2
Song Position Pointer
0xF3
Song Select
0xF4
Undefined
0xF5
Undefined
0xF6
Tune Request
0xF7
End Of System Exclusive Message
0xF8
Timing Clock
0xF9
Undefined
0xFA
Start
0xFB
Continue
0xFC
Stop(Stops All Sounds)
0xFD
Undefined
0xFE
Active Sensing
0xFF
System Reset
-Stop (Stops All Sounds): this command stops all playing sounds/notes.
-System Reset: this command performs an internal system reset of
SmartWAV2, same effect as a hardware reset.