SmartWAV2-MidiMode_R4

SMARTWAV 2

MIDI Mode

-All Sound Off: this command stops all playing sounds/notes.

-Reset All Controllers: this command performs an internal system reset

of SmartWAV2, same effect as a hardware reset.

-All Notes Off: this command stops all playing sounds/notes.

-Channel Omni Mode Off: this command disables the channel omni

mode and performs a reading on the hardware MIDI channel pins of

SmartWAV2 to set the MIDI channel, after this command is called, only

commands from 1 of the 16 MIDI channels will be processed.

-Channel Omni Mode On: this command enables the channel omni

mode and overrides any hardware MIDI channel pins configuration,

after this command is called, commands from all 16 MIDI channels will

be processed.

5.5 Program Change

Program Change commands modify the patch, instrument, voice or

sound type of a MIDI system, SmartWAV2 uses this command to

change/Go-in Go-Out folders named from “000” to “127” based on

the received program number parameter, if the MIDI host that will

control SmartWAV2 does not support program change commands,

then the “.wav” files must be placed on the root path (Refer to Section

5.3- MIDI Program Change/Folders Structure).

5.6 Channel Pressure

This command type is not supported by SmartWAV2 and all incoming

Channel Pressure commands are ignored.