SmartWAV2-MidiMode_R4

SMARTWAV 2

MIDI Mode

-Channel Volume: this command modifies the internal Master Gain

volume of the smartWAV2.

-Balance: this command modifies the internal panning of all the

playing tracks inside smartWAV2.

-Panning: this command modifies the internal panning of all the

playing tracks inside smartWAV2.

-Tracks Loop Enable/Disable: this command enables or disables the

looping functionality of all the playing tracks inside smartWAV2, this

command is useful for drum machines, to loop a rhythm track

constantly.

-Layer Velocity Enable/Disable: this command enables or disables the

note velocity layering functionality (Refer to MIDIConfig.txt file

section).

-Note OFF Enable/Disable: when enabled, the SmartWAV2 ignores all

incoming “Note OFF” commands (Useful for percussion sounds). (Refer

to MIDIConfig.txt file section).

-Audio Error Messages Enable/Disable: this command permanently

enables or disables the throwing of audible messages “No Memory

Card Detected” when SmartWAV2 is powered and no microSD card

is detected, by default those messages are enabled.

-Damper Pedal On/On (Sustain): This command

activates/deactivates the standard sustain functionality of all playing

notes.

-Release Time: this parameter is used to set the standard release time,

each unit of this received parameter increases/multiplies by 40ms of

time (Release Time = received parameter * 40ms), that means that

smartWAV2 can go from 0ms (received value 0) up to 5,080ms

(received value 127).