SmartWAV2-MidiMode_R4

SMARTWAV 2

MIDI Mode

4.1- MIDI Serial Mode 4 Hardware Typical Connection:

*The SmartWAV2 must always be powered with 2.7V-3.5V (Reset is 5V tolerant).

To receive midi commands the SmartWAV2 uses it RX pin (MIDI-IN),

MIDI works on a standard serial protocol (31250bps, 8bit, 1stop, no

parity), however the hardware interface of a standard serial TTL

USART/UART device is different from the hardware current-loop

interface of MIDI(opto-isolated), in order to connect a MIDI-OUT to

SmartWAV2 RX pin(MIDI-IN), a MIDI to serial TTL(0V-3.3V) converter is

required:

MIDI to Serial TTL converter.