SmartWAV2-MidiMode_R4

SMARTWAV 2
MIDI Mode
Vizic Technologies ©2020 | 12
8
TX - V-
NC
Not used, leave unconnected.
9
R-OUT
OUT
Pre-amplified right channel audio
output pin. Connect this pin instead of
the 3.5mm plug connector, those are
internally connected. (*Do not use
both plug and this pin at the same
time).
10
L-OUT
OUT
Pre-amplified left channel audio
output pin. Connect this pin instead of
the 3.5mm plug connector, those are
internally connected. (*Do not use
both plug and this pin at the same
time).
11
I4/I9 - STP
INPUT
Digital input pin MIDI omni-channel
enable/disable. Internally pulled-
down to ground via a 40K resistor.
12
I3/I8 - BCK
INPUT
Digital input pin MIDI channel selection
bit 3. Internally pulled-down to ground
via a 40K resistor.
13
I2/I7 - NXT
INPUT
Digital input pin MIDI channel selection
bit 2. Internally pulled-down to ground
via a 40K resistor.
14
I1/I6 - P/P
INPUT
Digital input pin MIDI channel selection
bit 1. Internally pulled-down to ground
via a 40K resistor.
15
I0/I5 - LOOP
INPUT
Digital input pin MIDI channel selection
bit 0. Internally pulled-down to ground
via a 40K resistor.
16
GND
POWER
Supply ground, be sure to have a well-
grounded connection to avoid noise
over the audio outputs.
*NC means no connect.