SmartWAV2-Datasheet_R4

SMARTWAV 2
Datasheet
Vizic Technologies ©2020 | 31
11
I4/I9 - STP
INPUT
Digital input pin MIDI omni-channel
enable/disable. Internally pulled-
down to ground via a 40K resistor.
12
I3/I8 - BCK
INPUT
Digital input pin MIDI channel selection
bit 3. Internally pulled-down to ground
via a 40K resistor.
13
I2/I7 - NXT
INPUT
Digital input pin MIDI channel selection
bit 2. Internally pulled-down to ground
via a 40K resistor.
14
I1/I6 - P/P
INPUT
Digital input pin MIDI channel selection
bit 1. Internally pulled-down to ground
via a 40K resistor.
15
I0/I5 - LOOP
INPUT
Digital input pin MIDI channel selection
bit 0. Internally pulled-down to ground
via a 40K resistor.
16
GND
POWER
Supply ground, be sure to have a well-
grounded connection to avoid noise
over the audio outputs.
*NC means no connect.
7.3- MIDI Serial Mode 4 Typical Connection:
*The SmartWAV 2 must always be powered with 2.7V-3.5V (Reset is 5V tolerant).