Specifications

Port Tab
130
LICENSED MATERIAL - PROPERTY OF FUJITSU SOFTWARE TECHNOLOGY CORPORATION
33
Start
transmitting/
Stop transmitting
(toggle button)
Initiates or stops the transmission of the selected
ordered set.
Note: Transmitting will automatically put the
selected port into bypass mode. It must manually be
put back into auto to rejoin the loop.
(pull-down list
of ordered sets)
under Match/
Count
Allows the user to select an ordered set to match on.
Match Sig (1x) Constitutes a match with one occurrence of the
ordered set.
Match Seq (3x) Constitutes a match with three consecutive
occurrences of the ordered set.
K28.5 “D” fields Allows the user to define the pattern to be matched
by filling in valid Fibre Channel data characters in
the “D” fields. An example would be to select the
OPN ordered set from the Match pull-down menu,
then add the specific source and destination AL_PA
values to the “D” fields. This would be a more
specific match than the standard OPN( ) from the
pull-down menu.
Counted Number of “D” character ordered sets that were
detected during the detection time. (All three of the
K28.5 “D” fields must be filled in.)
Note: The maximum number of ordered sets that
can be counted by
Softek SANView is 1,048,575.
Typical counts do not reach this maximum.
Captured Displays an ordered set that was matched or
transmitted.
Start detecting/
Stop detecting
(toggle button)
Initiates or stops the trigger for detecting the
selected match.
Detected Displays common ordered sets that have been
detected.
Port Tab Options 2
User Entry or
Selection Function