Hardware manual

TITAN SILICONSERVER HARDWARE MANUAL 25
Replacing Server Components
This section describes how to replace the hot-swappable components in the server. Follow the
procedure if you are a qualified System Administrator, Network Administrator, or Technician.
Replacing a Server Module
CAUTION: All power to the server must be switched off before replacing any modules.
1. Verify that the power switches on both the PSU’s are in the OFF position.
2. Unscrew the Retaining Screws (the screw is only a 1/4 turn) of the module. The Retaining Screws
are spring-loaded and remain in the module.
3. Remove the module by pulling and lifting the Ejection Levers outwards.
4. Slide the module carefully out of the enclosure.
5. Replace the module by sliding the new module in the correct position (refer to the module position
indicator) until it stops.
Note: Modules are ‘keyed’ only to fit into their correct slot. Therefore, do not try and force
a module into a different slot. The module position in the chassis is indicated by the
graphic in the bottom right hand corner of each module.
6. Lock the module in place by pushing inwards on the Ejection Levers until a click is heard.
7. Re-fasten the Retaining Screws.
8. Switch the power switches on the PSU’s to the ON position.
Ejection Lever
Module Position
Retaining Screws