English Warning Before Installation Power off the Video Server as soon as smoke or unusual odors are detected. Keep the Video Server away from water. If the Network Camera becomes wet, power off immediately. Contact your distributor in the event of occurrence. Contact your distributor in the event of occurrence. Do not place the Video Server around heat sources, such as a television or oven. Refer to your user's manual for the operating temperature. Keep the Video Server away from direct sunlight.
Do not place the Video Server on unsteady surfaces. Do not touch the Video Server during a lightning storm. Do not disassemble the Video Server. Do not drop the Video Server. Do not insert sharp or tiny objects into the Video Server.
English 1 Package Contents VS8102 Power Adapter Software CD Warranty Card Quick Installation Guide 3
2 Physical Description Front Panel SD/SDHC Card Slot BNC Video Input SD Card RCA Audio Input Audio Out Reset Audio In Video RCA Audio Output Recessed Reset Button Back Panel Ethernet 1 2 3 4 5 6 7 8 Ethernet 10/100 RJ45 Socket Power Cord Socket Status LEDs 4 General I/O Terminal Block
English 3 Network Deployment General Connection (without PoE) 1. Make video connection from the camera to the BNC video input. 2. Make audio connection from the Line-Out audio source to the RCA audio input. 3. Make audio connection from RCA audio output to the speaker. CAMERA NO. MIC 1 2 3 POWER OFF ON OUT VIDEO IN OUT 1 3 2 4. If you have external devices such as sensors and alarms, connect them to the general I/O terminal block. 5. Connect the Video Server to a switch via Ethernet cable. 6.
Power over Ethernet (PoE) When using a PoE-enabled switch The Video Server is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the Video Server to a PoE-enabled switch via Ethernet cable. POWER COLLISION 1 2 3 4 5 LINK RECEIVE PARTITION PoE Switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Video Server and a nonPoE switch.
English 4 Assigning an IP Address 1. Install "Installation Wizard 2" from the Software Utility directory on the software CD. 2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the "Next" button to continue the program. IW2 Installation Wizard 2 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN. 4. After searching, the main installer window will pop up.
5 Ready to Use 1. Access the Video Server from the LAN. 2. Retrieve live video through a web browser or recording software. For further setup, please refer to the user’s manual on the software CD.
