Installation guide

- 62 -
www.vivotek.com
Maintenance
Five actions can be selected.
“Reboot system” Click the reboot button to restart system.
“Restore” Click it to restore all setting to factory default except setting in “Network
type” in network page.
“Factory default” Click on Factory default button to restore the factory default
settings. Any changes made so far will be lost and the system will be reset to the initial
factory settings. The system will restart and require the installer program to set up the
network again.
“Upgrade firmware” Select the firmware file and click upgrade button.
“PTZ driver upload” Select the PTZ driver file and click upload button. The uploaded
PTZ driver will show up as “User uploaded driver” in the PTZ driver list in Camera
control page.