Installation guide

- 47 -
www.vivotek.com
Preset position
Preset positions
If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D protocol as the PTZ
driver and click the Save button, the Preset Position button will be enabled. Click
Preset Position to open the settings page. You can also select preset positions for the
camera to patrol. A total of 20 preset positions can be configured.
Please follow the steps below to preset a position:
1. Adjust the shooting area to the desired position using the buttons on the right side of
the window.
2. Enter a name for the preset position, which allows for up to forty characters. Click
Add to enable the settings. The preset positions will be displayed under the Preset
Location list on the left-hand side.
3. To add additional preset positions, please repeat steps 1~2.
4. To remove a preset position from the list, select it from the drop-down list and click
Delete.