User's Manual
Table Of Contents
- Overview
- Accessing the Network Camera
- Using 3GPP-compatible Mobile Devices
- Using RTSP Players
- Using VIVOTEK Recording Software
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout 
- System > Logs 
- System > Parameters 
- System > Maintenance
- Media > Image 
- Media > Video
- Media > Video
- Network > General settings
- Network > Streaming protocols 
- Network > SNMP (Simple Network Management Protocol)
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List 
- PTZ > PTZ settings
- Event > Event settings
- Applications > Motion detection
- Applications > Digital input
- Applications > Tampering detection
- Recording > Recording settings 
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
User's Manual - 9
6. Install and tighten the camera's rear cover.
7. Tighten the rubber seal, seal clamp, and cap nut of the waterproof connector.
9
8
6
7
8. Pass the cables through the center of the ball swivel mount bracket, one at a time.
9. Fasten the bracket to the camera using 3 hex socket screws.
NOTE:
The camera weighs up to 1.28 kgs. Make
sure the mounting surface can support this
camera.
IMPORTANT:
Whenever you want to open the camera canister, loosen the waterproof cable gland before
you loosen the rear cover. Otherwise, you can damage the cables attached to the inside of
the camera.