User Manual
Table Of Contents
- Read Before Use
- Overview
- Hardware Installation
- Accessing the Network Camera
- Using VIVOTEK Recording Software
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout
- System > Logs
- System > Parameters
- System > Maintenance
- Media > Image
- Media > Video
- ■ Smart stream III
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > DDNS
- Network > SNMP (Simple Network Management Protocol)
- Network > FTP
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL/TLS)
- Security > Access List
- PTZ > PTZ settings
- Event > Event settings
- Applications > Motion detection
- Applications > DI and DO
- Applications > Tampering detection
- Applications > Audio detection
- Applications > VADP (VIVOTEK Application Development Platform)
- Recording > Recording settings
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
User's Manual - 5
Package Contents
■ SD9374
■ Wall Mount Bracket / Screws
■ Screws and anchors / Alignment Sticker / T10, T20 and T25 L-wrench
■ Safety wire bracket and screws
■ Quick Installation Guide
■ IO Combo Cable (may come with one 1m combo cable or Separately Purchased depending on sales
regions)
■ RJ45 Ethernet connector
Symbols and Statements in this Document
i
INFORMATION: provides important messages or advices that might help prevent inconvenient
or problem situations.
NOTE: Notices provide guidance or advices that are related to the functional integrity of the
machine.
Tips: Tips are useful information that helps enhance or facilitae an installation, function, or
process.
WARNING: or IMPORTANT:: These statements indicate situations that can be dangerous or
hazardous to the machine or you.
Electrical Hazard: This statement appears when high voltage electrical hazards might occur
to an operator.
IMPORTANT:
WARNING:
These devices(IR LED) emit highly concentrated infrared light, which view angle(range) is
smoothly varied depending on operation mode.
To avoid risk of eye injury, please do
not look directly at the LEDs at a near distance and remember to use the
camera live view to check if the IR illumination is active!
Below are the requirements for powering the the speed dome:
Power source Power Consumption
AC 24V & DC 24V Max. 96W (heater and fan on); Max. 45W (heater and fan off)
High power PoE Max. 70W (heater and fan on); Max. 39W (heater and fan off), using VIVOTEK's
AP-GIC-011A-095
.