User Manual
Table Of Contents
- Overview
- Hardware Installation
- Accessing the Network Camera
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout
- System > Logs
- System > Parameters
- System > Maintenance
- Media > Image
- Media > Video
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > DDNS
- Network > SNMP (Simple Network Management Protocol)
- Security > User Account
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List
- PTZ > PTZ settings
- Event > Event settings
- Applications > Motion detection
- Applications > DI and DO
- Applications > Audio detection
- Applications > Package management (VADP - VIVOTEK Application Development Platform)
- Recording > Recording settings
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
User's Manual - 21
C-3. Install the camera. Use an electric screwdriver to lower the clamping plates until they rest
against the ceiling board so that the ceiling/board is caught between the clamps and the
ang on the other side of the ceiling. Do not over-tighten the clamps to avoid damages to the
ceiling board.
Clockwise
Counter-
clockwise
C-4. Secure the trim ring using a Phillips screwdriver.