Quick Installation Guide English 繁中 簡中 日本語 Français Español Deutsch Português SD8111/SD8121 H.264 12x Zoom Day&Night 3D Noise Reduction P/N: 625012000G Ver.1.0 Copyright c 2010 VIVOTEK INC. All rights reserved.
English Warning Before Installation Power off the Network Camera as soon as smoke or unusual odors are detected. Contact your distributor in the event of occurrence. Keep the Network Camera away from water. If the Network Camera becomes wet, power off immediately. Contact your distributor in the event of occurrence. Do not place the Network Camera around heat sources, such as a television or oven. Refer to your user's manual for the operating temperature.
Do not place the Network Camera on unsteady surfaces. Do not touch the Network Camera during a lightning storm. Do not disassemble the Network Camera. Do not drop the Network Camera. Do not insert sharp or tiny objects into the Network Camera.
English 1 Package Contents SD8111 / SD8121 Hard Ceiling Mount Bracket and Decoration Ring Cable Connector (Power, Video Out, Mic In, Audio Out, Ground) DI/DO Cable Connector Power Adaptor Fixing Plate Quick Installation Guide / Warranty Card Software CD 510000210G EN - 3
2 Physical Description SD/SDHC Card Slot Lens Dome Cover Record the MAC address before installing the camera.
English 3 Hardware Installation Follow the steps below to install the Network Camera to the ceiling: 1. Detach the Decoration Ring from the Hard Ceiling Mount Bracket. 2. Align the three holes on the Mount Bracket, mark the screws locations on the ceiling. 3. Drill three pilot holes into the ceilling and hammer the plastic anchors into the holes. 4. Fix the Mount Bracket with three screws.
5. Put the decoration ring onto the dome body. 6. Insert the fixing plate into the groove as shown below. 7. Align the three holes to screw the fixing plate to the dome base.
Pin Definitions of Cable Connector 2 4 22 1 3 21 00 02 D1 07 25 8A 12: DI 0 13: DI 2 14: DI 1 15: DI 3 16: DO 8 A 9 8 B a 00 02 D10 72 58 A 9 b EN - 7 c English 8. If you have external devices such as sensors and alarms, connect them to the general I/O terminal block. Then connect the cable connector and Ethernet cable to the dome base. 9. Align plate A and plate B, use hole a ~ c to hook the Network Camera on the ceiling mount bracket.
10. Tighten the screw on the fixing plate. 11. Align the three holes to mount the decoration ring. 10 11 12. Connect the cables and make the network deployment.
English 4 Assigning an IP Address 1. Install “Installation Wizard 2” from the Software Utility directory on the software CD. 2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the “Next” button to continue the program. Installation Wizard 2 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN. 4. After searching, the main installer window will pop up.
5 Ready to Use 1. Access the Network Camera on the LAN. 2. Retrieve live video through a web browser or recording software. 2010/06/09 10:25:23 For further setup, please refer to the user's manual on the software CD.
Quick Installation Guide English 繁中 簡中 日本語 Français Español Deutsch Português SD8111/SD8121 H.264 12x Zoom Day&Night 3D Noise Reduction P/N: 625012000G Ver.1.0 Copyright c 2010 VIVOTEK INC. All rights reserved.