User Manual
Table Of Contents
- Chapter One Hardware Installation and Initial Configuration
- Section One
- Management over a
- Local Console
- Chapter Two
- Introduction to the Local Console Interface
- Chapter Three
- Configuation Using the Local Console
- The Main Control Portal
- 3-3-1. Basic Search
- 3-3-2. Alarm Search
- 3-3-3. POS Search
- 3-3-4. Smart Search II
- 3-3-5. Smart VCA event search
- 3-3-6. Storyboard
- 3-5-1. Settings - Overview
- 3-5-2. Settings–Camera–Management
- 3-5-3. Settings–Camera–Recording
- 3-5-4. Settings–Camera–Recording
- 3-5-5. Settings–Camera–Media
- 3-5-6. Settings - Camera - Image
- 3-5-7. Settings–Camera–Motion Detection
- 3-5-8. Settings - Camera - PTZ settings
- 3-5-9. Settings - Camera - Port forwarding
- 3-5-10. Settings - Camera - Update firmware
- 3-5-11. Settings–Alarm–Alarm
- 3-5-12. Settings - Alarm - Email
- 3-5-13. Settings–System–Information
- 3-5-14. Settings–System–Maintenance
- 3-5-15. Settings - System - Display
- 3-5-16. Settings - System - UPS
- 3-5-17. Settings - System - Log
- 3-5-18. Settings - System - VIVOCloud service
- 3-5-19. Settings–User
- 3-5-20. Settings–User-Login / Logout
- 3-5-21. Settings–Storage
- 3-5-22. Settings - Storage - Scheduled backup
- 3-5-23. Settings - Network
- Settings - Network - IP
- Settings - DDNS
- Settings–Service
- Section Two
- Management over a Web Console
- Chapter Four Login and Getting Started
- 4-1. Login
- 4-2. Graphical Layout and Screen Elements - Liveview
- 4-2-4. Logo & Menu
- 4-2-5. View Cell panel
- 4-2-6. PTZ panel
- Adding Cameras to View Cells
- 4-2-7. Alarm panel
- 4-3. Graphical Layout and Screen Elements - Search recording clips
- 4-3-4. View Cells in Search Recording Clips
- 4-3-6. Calendar Panel
- 4-3-5. Alarm Panel
- Search Recording Clips Control Panel
- Chapter Five System Settings
- Chapter Six Operation
- Safety and Compatibility
VIVOTEK - Built with Reliability
40 - User's Manual
List of preset positions
Focus far
Focus near
Starts patrol
Zoom out
Zoom in
Speed selector
1. PTZ control: Click on the arrow buttons to move towards the direction you wish to
move to.
2. Focus: Click on the Focus near and Focus far buttons to adjust camera focus.
3. Zoom: Use the Zoom in and Zoom out buttons to adjust the camera's zoom ratio.
4. Presets: If you congured preset positions, a list of preset positions will appear.
5. Speed: Adjusts the speed when moving across the eld of view.
6. Patrol: If you congured preset positions into a patrolling tour, click on this button
and the camera will proceed with patrolling through the preset points.
Below is the PTZ panel that appears with ordinary PTZ cameras.
This portal appears with a sheye camera. Since it is for the sheye camera,
the PiP and PTZ buttons will then be disabled.
Due to the limitation of system resources, the sheye dewarp (1R & 1P) can
only take place on one view cell, for one sheye camera.
IMPORTANT: