User Manual
Table Of Contents
- Chapter One Hardware Installation and Initial Configuration
- Section One
- Management over a
- Local Console
- Chapter Two
- Introduction to the Local Console Interface
- Chapter Three
- Configuation Using the Local Console
- The Main Control Portal
- 3-3-1. Basic Search
- 3-3-2. Alarm Search
- 3-3-3. POS Search
- 3-3-4. Smart Search II
- 3-3-5. Smart VCA event search
- 3-3-6. Storyboard
- 3-5-1. Settings - Overview
- 3-5-2. Settings–Camera–Management
- 3-5-3. Settings–Camera–Recording
- 3-5-4. Settings–Camera–Recording
- 3-5-5. Settings–Camera–Media
- 3-5-6. Settings - Camera - Image
- 3-5-7. Settings–Camera–Motion Detection
- 3-5-8. Settings - Camera - PTZ settings
- 3-5-9. Settings - Camera - Port forwarding
- 3-5-10. Settings - Camera - Update firmware
- 3-5-11. Settings–Alarm–Alarm
- 3-5-12. Settings - Alarm - Email
- 3-5-13. Settings–System–Information
- 3-5-14. Settings–System–Maintenance
- 3-5-15. Settings - System - Display
- 3-5-16. Settings - System - UPS
- 3-5-17. Settings - System - Log
- 3-5-18. Settings - System - VIVOCloud service
- 3-5-19. Settings–User
- 3-5-20. Settings–User-Login / Logout
- 3-5-21. Settings–Storage
- 3-5-22. Settings - Storage - Scheduled backup
- 3-5-23. Settings - Network
- Settings - Network - IP
- Settings - DDNS
- Settings–Service
- Section Two
- Management over a Web Console
- Chapter Four Login and Getting Started
- 4-1. Login
- 4-2. Graphical Layout and Screen Elements - Liveview
- 4-2-4. Logo & Menu
- 4-2-5. View Cell panel
- 4-2-6. PTZ panel
- Adding Cameras to View Cells
- 4-2-7. Alarm panel
- 4-3. Graphical Layout and Screen Elements - Search recording clips
- 4-3-4. View Cells in Search Recording Clips
- 4-3-6. Calendar Panel
- 4-3-5. Alarm Panel
- Search Recording Clips Control Panel
- Chapter Five System Settings
- Chapter Six Operation
- Safety and Compatibility
VIVOTEK - Built with Reliability
User's Manual - 105
3. On the Trigger window, select system triggering conditions, or one or more cameras by
selecting their checkboxes. The number of DI or DOs on each camera is automatically
detected and displayed through individual checkboxes. The Motion detection function, if
there are many detection windows congured on a camera, is all triggered by one checkbox.
Note that the triggering sources will be listed even if the camera is currently not connected.
You may also select the "Copy trigger from" menu to borrow the setting you previously
congured.
Click on the next button
to proceed.