Quick Start Guide

EN - 9

WhenchoosingthelensforyourIP8172/72P,pleasenoticethespecicationsasbelow.

1. Flange back length [distance A-B (CMOS sensor)] must be longer than 12.5mm. If

theangebacklengthistooshort,thebottomofscrewmountmayhittheIRCut

Filter, or result in out of focus when adjusting the focus controller.

2. The screw mount (distance A-C) must be shorter than 5.2mm; in case that the bottom

of screw mount may hit the IR Cut Filter.

3. The distance between the edge of lens (D) and front panel (E) must be longer than

0.5mm; or, it may hit the front panel when adjusting the focus controller, or result in

out of focus.

D (lens edge)

E (front panel)

IR Cut

Filter

A C

NOTE: