Warning Before Installation Power off the Network Camera as soon as smoke or unusual odors are detected. Keep the Network Camera away from water. If the Network Camera becomes wet, power off immediately. Do not place the Network Camera around heat sources, such as a television or oven. Keep the Network Camera away from direct sunlight. Refer to your user's manual for the operating temperature. Do not place the Network Camera on unsteady surfaces.
2 Physical Description Front Panel Status LED MicroSD/ SDHC/ SDXC Card Slot Lens Mount ring adjustment Rear Panel Iris Control Cable Socket 1 2 3 4 5 6 7 AUDIO_OUT MIC_IN GND_AUDIO RS485_P Ethernet 10/100 RJ45 Socket RS485_N DI GND Mounting Hole General I/O Terminal Block Recessed Reset Button Lens Focus Controller Zoom Controller EN - 2
English 3 Mounting the Lens to the Camera 1. Mount the lens by turning it clockwise onto the camera mount until it stops. 2. Connect the iris control cable to the socket. Connect the iris control cable before power-on. Otherwise, you will not be able to access the exposure related settings. 2 1 4 Mounting the Camera to Stand 1. Use the holes on the camera stand to mark drill holes on the wall. Drill holes on your preferred location. 2. Hammer in the included plastic anchors. 3.
Network Deployment Power over Ethernet (PoE) When using a PoE-enabled switch The Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the Network Camera to a PoE-enabled switch via Ethernet cable. PoE Switch POWER COLLISION 1 2 3 4 5 LINK RECEIVE PARTITION When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.
English 6 Assigning an IP Address 1. Install "Installation Wizard 2" from the Software Utility directory on the software CD. 2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the "Next" button to continue the program. 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN. 4. After a brief search, the main installer window will pop up.
3. Unscrew the zoom controller to adjust the zoom factor. Upon completion, tighten the zoom controller. 4. Unscrew the focus controller to adjust the focus range. Upon completion, tighten the focus controller. ∞ 3 4 N W T NOTE: If you prefer other lens for your IP8152, please notice the specifications below. 1. If you select a different lens, the distance between the flange of the lens and the IR cut filter on the camera should be smaller than 7.5mm.
