English Warning Before Installation Power off the Network Camera as soon as smoke or unusual odors are detected. Contact your distributor in the event of occurrence. Keep the Network Camera away from water. If the Network Camera becomes wet, power off immediately. Contact your distributor in the event of occurrence. Do not place the Network Camera around heat sources, such as a television or oven. Refer to your user’s manual for the operating temperature.
Do not place the Network Camera on unsteady surfaces. Do not touch the Network Camera during a lightning storm. Do not disassemble the Network Camera. Do not drop the Network Camera. Do not insert sharp or tiny objects into the Network Camera.
English 1 Package Contents IP8132 IP8133 IP8133W Camera Stand Power Adaptor (+5V, 2A) & Ferrite Core Software CD 510000202G Warranty Card Quick Installation Guide Screws Antennas (IP8133W) EN - 3
2 Physical Description Front Panel IP8132 Status LED Microphone Lens NOTE: The front view of IP8133 is identical to that of IP8133W except the wireless antenna. Status LED IP8133W Microphone Speaker White-light LED PIR Sensor LED Definitions Item LED status Description 1 Steady Red Red LED off Blink Green every 1 sec. Steady Red Power on and system boot Power off Network connected Network failed Blink Green every 2 sec. Blink Orange every 2 sec.
English Back Panel IP8132 Ethernet 10/100 RJ45 Socket General I/O Terminal Block Power Cord Socket Recessed Reset Button IP8132 MAC:0002D132C353 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Pat.
3 Install Ferrite Core 1. Unsnap the two halves of the ferrite core. 2. Attach the ferrite core to the power cord as close to the DC connector as possible. Fold the ferrite core over the power cord, wrap the power cord once, and snap the small latches together. Ferrite Core 4 Network Deployment LAN Connection 1. If you have external devices such as sensors and alarms, make connections from general I/O terminal block.
English Wireless Connection: Using the WPS Button 1. Make sure your AP (Access Point) and Operating System support WPS (Wi-Fi Protected Setup) functions. WPS enables easy setup with compatible APs. 2. Disconnect your LAN cable, and wait for the LED to turn red. 3. Press the WPS button for 1 second. You can then hear vocal instructions (in English) from the camera speaker. 4. Press and hold down the WPS button on your AP (some router/AP will have a virtual button on their management software instead).
4 Assigning an IP Address 1. Install “Installation Wizard 2” from the Software Utility directory on the software CD. 2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the “Next” button to continue the program. Installation Wizard 2 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN. 4. After a brief search, the main installer window will pop up.
720p HD WDR Pro IP67 Quick Installation Guide English 繁中 簡中 日本語 Français Español Deutsch Português Italiano Türkçe Polski Русский Česky Svenska IP8335H This guide describes the basic functions of IP8335H. More details can be found in the User Manual. Copyright New Taipei City P/N: 625015800G Ver.1.0 2011 VIVOTEK INC. All right reserved.
