Quick Start Guide

EN - 6

Network Deployment

1. If you have external devices such as sensors and alarms, make connections from

general I/O terminal block.

MAC:0002D132C353

IP8132

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Pat. 6,930,709

POWER

COLLISION

LINK

RECEIVE

PARTITION

3. Connect the supplied

power cable from the

camera to a power

outlet.

2. Connect the camera to a switch

via Ethernet cable.

4: Power

3: Digital output

2: Digital input

1: Ground

LAN Connection

NOTE:

1. Use a Category 5 Cross Cable when

Network Camera is directly connected

to a PC.

2. The IP8133 can acquire power through

a cable connection with a PoE switch.

However, when so connected, the camera

is only to be connected to PoE networks

without routing to outside plants.

Install Ferrite Core

1. Unsnap the two halves of the ferrite core.

2. Attach the ferrite core to the power cord as close to the DC connector as possible.

Fold the ferrite core over the power cord, wrap the power cord once, and snap the

small latches together.

Ferrite Core