user manual
Table Of Contents
- Overview
- Accessing the Network Camera
- Using 3GPP-compatible Mobile Devices
- Using RTSP Players
- Using VIVOTEK Recording Software
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout 
- System > Logs 
- System > Parameters 
- System > Maintenance
- Media > Image 
- Media > Video
- Media > Video
- Network > General settings
- Network > Streaming protocols 
- Network > SNMP (Simple Network Management Protocol)
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List 
- PTZ > PTZ settings
- Event > Event settings
- Applications > Motion detection
- Applications > Digital input
- Applications > Tampering detection
- Recording > Recording settings 
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
User's Manual - 59
NOTE
► If the default ports are already used by other devices connected to the same router, the Network
Camera will select other ports for the Network Camera.
► If UPnP
TM
is not supported by your router, you will see the following message:
Error: Router does not support UPnP port forwarding.
► Steps to enable the UPnP
TM
user interface on your computer:
Note that you must log on to the computer as a system administrator to install the UPnP
TM
components.
1. Go to Start, click Control Panel, then click Add or Remove Programs.
2. In the Add or Remove Programs dialog box, click Add/Remove Windows Components.
3.
In the Windows Components Wizard dialog box, select Networking Services and click
Details.
NOTE: