user manual
Table Of Contents
- Overview
- Accessing the Network Camera
- Using 3GPP-compatible Mobile Devices
- Using RTSP Players
- Using VIVOTEK Recording Software
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout 
- System > Logs 
- System > Parameters 
- System > Maintenance
- Media > Image 
- Media > Video
- Media > Video
- Network > General settings
- Network > Streaming protocols 
- Network > SNMP (Simple Network Management Protocol)
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List 
- PTZ > PTZ settings
- Event > Event settings
- Applications > Motion detection
- Applications > Digital input
- Applications > Tampering detection
- Recording > Recording settings 
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
User's Manual - 11
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press the recessed reset button. Wait for the Network Camera to reboot.
Restore: Press and hold the reset button until the status LED rapidly blinks. Note that all settings
will be restored to factory default. Upon successful restore, the status LED will blink green and
red during normal operation.
Micro SD/SDHC Card Capacity
This network camera is compliant with Micro SD/SDHC 16GB / 8GB / 32GB and other
preceding standard SD cards.
Reset Button