User Manual
Table Of Contents
- Overview
- Accessing the Network Camera
- Using VIVOTEK Recording Software
- Using 3GPP-compatible Mobile Devices
- Using RTSP Players
- Main Page
- Client Settings
- Configuration
- System > General settings
- System > Homepage layout
- System > Logs
- System > Parameters
- System > Maintenance
- Media > Image
- Media > Video
- Media > Video
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > SNMP (Simple Network Management Protocol)
- Network > FTP
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List
- PTZ > PTZ settings
- Event > Event settings
- Applications > Motion detection
- Applications > DI and DO
- Applications > Tampering detection
- Applications > Audio detection
- Applications > PIR (FD9167)
- Applications > Package management - a.k.a., VADP (VIVOTEK Application Development Platform)
- Recording > Recording settings
- Local storage > SD card management
- Local storage > Content management
- Appendix
VIVOTEK
20 - User's Manual
8. Use the alignment sticker to drill mounting holes on the ceiling or wall. If preferred, drill a
routing hole. Install the camera by hammer in the wall anchors and drive screws.
A
9. When fastening the screws, do not completely tighten the screws. Pass cables through
the routing holes, and then mount the camera by passing the screw heads through the
keyhole slots. Turn the camera counter-clockwise, and then fasten the screws.