User`s manual

VIVOTEK
18 - User's Manual
1� Disassemble the components of the
waterproof connector into parts (A) ~ (F)
as shown above�
2� Place the screw nut (E) on the Power and
GPIO opening�
3� Feed the power cables through the
waterproof connector (F --> E --> D -->
B --> A) as the illustration shows� Then
connect the power cables to the power
source. Note: There are 8 holes on the
seal (D), and the widest holes with a crack
on the side are specic for power cables.
4� If you have external devices such as
sensors and alarms, feed the cables
through the waterproof connector (F --> E
--> D --> B --> A) as previously described�
Assembling Steps
Sealing Nut (A)
Housing (B)
Seals (C)
Seal (D)
Screw Nut (E)
Hex Nut (F)
Waterproof Connector
(A)
(B)
(D)
(E)
(F)
Refer to the pin denition to connect them
to the general I/O terminal block. Note:
The recommended cable gauge is 2�0 ~
2�8 mm�
5� Push the seal (D) into the housing (B)�
6� Insert the seals (C) into unused holes on
the seal (D) to avoid moisture�
7� Secure the sealing nut (A) tightly and hex
nut (F) from the bottom of the camera�