User`s manual

VIVOTEK
206 - User's Manual
function zoom,
focus,
auto,
scan,
stop,
positioning
getstatus
Function type
zoom – Move zoom motor
focus – Move focus motor
auto – Perform auto focus
scan – Perform focus scan
stop – Stop current operation
positioning – Position the motors
getstatus – Information of motors, return value as below:
remote_focus_focus_motor_max: Maximum steps of focus
motor
remote_focus_zoom_motor_max: Maximum steps of zoom
motor
remote_focus_focus_motor_start: Start point of effective
focal length
remote_focus_focus_motor_end: End point of effective focal
length
remote_focus_focus_motor: Current position of focus motor
remote_focus_zoom_motor: Current position of zoom motor
remote_focus_focus_enable: Current function of focus motor
remote_focus_zoom_enable: Current function of zoom motor
remote_focus_value_mode: Source of focus value. 0: ISP, 1:
Edge.
direction direct,
forward,
backward
Motor’s moving direction.
It works only if function=zoom | focus.
position 0 ~ <motor_max> Motor’s position.
It works only if function=zoom | focus and direction=direct.
<motor_max> is refer to remote_focus_focus_motor_max or
remote_focus_zoom_motor_max which replied from
"function=getstatus"
steps 1 ~ <motor_max> Motor’s moving steps.
It works only if function=zoom | focus and direction=forward |
backward.
<motor_max> is refer to remote_focus_focus_motor_max or
remote_focus_zoom_motor_max which replied from
"function=getstatus"
iris N/A Open iris or not.
It works only if function=auto | scan.