Manual

VIVOTEK
User's Manual - 7
Hardware Installation
Removing the Dome Cover
0002D10766AD
FD8152V-F2
2� Record the MAC address before
installing the camera�
IMPORTANT:
1� It is recommended to use an Ethernet
cable that comes without the strain relief
boot� You can remove the boot if your cable
comes with one�
Strain relief boot
NOTE:
3. You can check the model name sufx
for the type of lens mounted on your
camera. The applicable lens can be:
F2: 2.4mm; F4: 4mm; F8: 8mm. The
shorter the focal length, the wider the
view�
2� As shown below, you may also route cable
from the side�
1� The camera is not likely to require
connection to an Ethernet network
with outside plant routing, including
campus environment; and the ITE is
to be connected only to PoE networks
without routing to the outside plant�
1� Unscrew the anit-tamper screws using the
included screwdriver�
2� Remove the dome cover�
3� Remove the slide cover if you want to route
cables from the side of camera instead of a
hole on the ceiling or wall�