User manual

Electromagnetic Compatibility (EMC)
This device compiles with FCC Rules Part 15. Operation is subject to the following
two conditions.
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that
may cause undesired operation.
USA - This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a partial installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the seperation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission limits.
Europe
- This digital equipment fulfills the requirement for radiated emission
according to limit B of EN55022/1998, and the requirement for immunity according
to EN50082-1/1992.
Liability
Vivotek Inc. cannot be held responsible for any technical or typographical errors and
reserves the right to make changes to the product and manuals without prior notice.
Vivotek Inc. makes no warranty of any kind with regard to the material contained
within this document, including, but not limited to, the implied warranties of
merchantability and fitness for any particular purpose.