User Manual
Table Of Contents
- Software Installation on page 10
- Revision History
- Overview
- Network Deployment
- Accessing the Network Camera
- Main Page
- Client Settings
- Configuration
- System > Homepage layout 
- System > Logs 
- System > Parameters 
- System > Maintenance
- Media > Image 
- Media > Video
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > QoS (Quality of Service)
- Network > SNMP (Simple Network Management Protocol)
- Network > FTP
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List 
- Security > IEEE 802.1x
- PTZ > PTZ settings
- Event > Event settings 
- Applications > Motion detection
- Applications > Tampering detection
- Applications > Audio detection
- Applications > Package management - a.k.a., VADP (VIVOTEK Application Development Platform)
- Recording > Recording settings 
- Appendix
VIVOTEK
52 - User's Manual
If you want to congure another sensor setting using the schedule mode, please click Prole to open
the Prole Settings page as shown below.
Please follow the steps below to setup a prole:
1. Select the Enable and apply this prole checkbox.
2. Select the Schedule mode. Please manually enter a range of time.
3. Congure the White balance and Image adjustment settings in the following columns. Please refer to the
previous page for detailed information.
4. Click Save to enable the settings and click Close to exit the page.