User Manual
Table Of Contents
- Software Installation on page 10
- Revision History
- Overview
- Network Deployment
- Accessing the Network Camera
- Main Page
- Client Settings
- Configuration
- System > Homepage layout 
- System > Logs 
- System > Parameters 
- System > Maintenance
- Media > Image 
- Media > Video
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > QoS (Quality of Service)
- Network > SNMP (Simple Network Management Protocol)
- Network > FTP
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List 
- Security > IEEE 802.1x
- PTZ > PTZ settings
- Event > Event settings 
- Applications > Motion detection
- Applications > Tampering detection
- Applications > Audio detection
- Applications > Package management - a.k.a., VADP (VIVOTEK Application Development Platform)
- Recording > Recording settings 
- Appendix
VIVOTEK
User's Manual - 33
Joystick Settings
Enable Joystick
Connect to the USB plug of the joystick to a USB port on your management computer. Supported by
the plug-in in the main page (Microsoft’s DirectX), once the plug-in in the main page is loaded, it will
automatically detect if there is any joystick on the computer. The joystick should work properly without
installing any other driver or software.
Then you can begin to congure the joystick settings of connected devices. Please follow the instructions
below to enable joystick settings.
1. Right-click on a live view window. Select Joystick Settings. If your joystick is working properly, it will be
displayed on the drop-down list.
c. Select the joystick you want to congure. Check Enable Joystick, then click Congure Buttons to
open Buttons conguration window.