User Manual
Table Of Contents
- Software Installation on page 10
- Revision History
- Overview
- Network Deployment
- Accessing the Network Camera
- Main Page
- Client Settings
- Configuration
- System > Homepage layout 
- System > Logs 
- System > Parameters 
- System > Maintenance
- Media > Image 
- Media > Video
- Media > Audio
- Network > General settings
- Network > Streaming protocols
- Network > QoS (Quality of Service)
- Network > SNMP (Simple Network Management Protocol)
- Network > FTP
- Security > User accounts
- Security > HTTPS (Hypertext Transfer Protocol over SSL)
- Security > Access List 
- Security > IEEE 802.1x
- PTZ > PTZ settings
- Event > Event settings 
- Applications > Motion detection
- Applications > Tampering detection
- Applications > Audio detection
- Applications > Package management - a.k.a., VADP (VIVOTEK Application Development Platform)
- Recording > Recording settings 
- Appendix
VIVOTEK
User's Manual - 169
44
videoin_maxframerate <a list of available
maximum frame rate
separated by
commas>
30,
30,
30,
30,
30
0/7 Available maximum
frame list.
videoin_codec
mjpeg, h264 mjpeg,
h264
0/7 Available codec list.
videoout_codec
<a list of the
available codec types
separated by
commas)
7,7 0/7 Available codec list.
audioin_codec
g711 g711 0/7 Available codec list for
audio input.
uart_httptunnel <boolean> 0 0/7 Indicate whether to
support HTTP tunnel for
UART transfer.
camctrl_httptunnel <boolean> 0 0/7 The attribute indicates
whether sending camera
control commands
through HTTP tunnel is
supported.
0: Not supported
1: Supported
camctrl_privilege <boolean> 1 0/7 Indicate whether to
support “Manage
Privilege” of PTZ control
in the Security page.
1: support both
/cgi-bin/camctrl/camctrl.c
gi and
/cgi-bin/viewer/camctrl.cg
i
0: support only
/cgi-bin/viewer/camctrl.cg
i
transmission_mode
Tx TX 0/7 Indicate transmission
mode of the machine: TX
= server, Rx = receiver