Instructions / Assembly

NEVER PUT HANDS OR FACE DIRECTLY OVER BURNER WHILE LIGHTING
OR WHILE THE APPLIANCE IS LIT
FOR MODELS WITH ADJUSTABLE REGULATORS
(ILLUSTRATIONS PAGE 7)
1. Check the casting to make sure it is set up as per the illustration (Figure 1).
2. Make sure that the regulator control is turned OFF by turning it counterclockwise
until it reaches the stop.
3. Open cylinder control valve by turning it counterclockwise as per the diagram
(Figure 2).
4. Insert a multipurpose lighter through the hole in the shroud as per Figure 4, or use
a paper book match placed above the casting as per Figure 5. Turn the regulator
control toward the ON position until ignition occurs. Turning the regulator control
clockwise increases the gas pressure to the burner and hence the ame size (Figure
2). When lighting the stove, if ignition does not occur in 3 to 5 seconds, turn the
regulator and cylinder valve o. Wait 5 minutes for gas to disperse. Repeat the steps.
5. Check that the ame is blue and that the ames are emitted from every port in the
casting. If not, rotate the air shutter position until there is a blue ame. Opening the
shutter too much will cause the ame to “Lift” o the burner (Figure 6). If there is a
yellow ame, or if some ports have no ame, this indicates there may be an
obstruction in the venturi tube or ports. Check the maintenance instructions on
page 4 for more information regarding a yellow ame.
6. Always monitor the ame throughout the cooking process. If at any point in the
cooking process the ame is accidentally extinguished, immediately turn the
regulator and cylinder valve OFF. Wait 5 minutes for gas to disperse and relight the
cooker according to the lighting instructions (#1-5) in this section.
FOR MODELS WITH MANUAL VALVE(S) CONTROLS
(ILLUSTRATIONS PAGE 7)
1. Check the casting to make sure it is set up as per the illustration (Figure 1).
2. Make sure that the manual valve(s) is turned OFF by turning it clockwise until it
reaches the stop.
3. Open cylinder control valve by turning it counter clockwise as per the diagram
(Figure 3).
4. Insert a multipurpose lighter through the hole in the shroud as per Figure 4, or use
a paper book match placed above the casting as per Figure 5. Turn the manual
valve control toward the ON position until ignition occurs. Turning the manual valve
counterclockwise to increase the gas ow to the burner and hence the ame size
WARNING! !
-6-
Lighting & Operating Instructions