Use And Care Manual

MOUNTING

Adhesive Tape

To mount your sensor to a wall, follow the steps below.

1. Remove the battery compartment cover from your sensor. Use the

holes in the cover as guides to drill two holes in your wall.

2. Insert the included mounting brackets into the two holes in your

wall. Then insert the included screws into the mounting brackets,

leaving approximately 5-8mm extended from the wall. Reattach the

battery compartment cover onto your sensor, and then hang the

sensor onto the two screws.

3. As an alternative to using screws, you use the included adhesive

tape to attach your sensor to your wall.

4. Use the second included piece of adhesive tape to attach the

probe case to the wall. Leave no space between the probes and the

ground.