Use And Care Manual

AP Mode

NOTES

12.

--Your sensor will emit a series of beeping sounds when the probes

are exposed to water.

--To test if your sensor is working press and hold the probes down

for several seconds. The sensor should emit a beep.

--To test the sensor’s Wi-Fi status, quickly push down on the

probes. If the LED indicator light quickly turns purple and ﬂashes,

then the sensor in not connected to Wi-Fi. If it quickly turns blue

and ﬂashes, then Wi-Fi is connected.

--If you press the power button for 2-3 seconds, the LED indicator

light will turn red and ﬂash slowly. This indicates that you are in AP

Mode. Use AP Mode only if you want to use your sensor with your

phone, but do not have access to Wi-Fi and your phone will be in

close proximity to your sensor. Press and hold the power button

for 7 seconds to switch between AP mode and standard Wi-Fi

quick connect mode. The LED indicator light will ﬂash rapidly when

in Wi-Fi quick connect mode.