Use And Care Manual

General Installation

MOUNTING

AC 12V~24V

To mount your doorbell to a wall, follow the steps below.

1. Use the wall mount attached to the rear of your doorbell, to mark

the precise points on your wall to drill holes.

2. Drill holes into your wall at the marked points, then insert the

included mounting anchors into holes.

3. Use the included screws to attach the wall mount to the wall,

making sure the screws go through the mounting anchors. If desired

you can also attach the included angled wall mount to the wall, and

then attach the wall mount to the angled wall mount.

4. To power your doorbell, connect your home’s corresponding

electrical cables to the external power ports on your doorbell. It does

not matter which cable goes to which port. Then attach the doorbell

to the wall mount. If you are unfamiliar or inexperienced with your

home’s electrical systems, contact a certiﬁed electrician for

assistance.