Operating Instructions
Page 6 of 15
This kind of remote managed network provides the means for building the network at a pace
fitting the area and must not be fully deployed before taken into use.
Hands on work on the equipment is only required at installation, or if service is required.
3.1. Preconditions
The preconditions for using a Pandora is that the installation and use in all parts follow what has
been stated by the supplier and manufacturer.
All other uses must be clarified and approved by the supplier/manufacturer! If not it is regarded
as a non-approved installation which will become the sole responsibility of the installer.
3.2. Intended Use
The Pandora is intended for outdoor use in broadband mesh configurations. It is managed and
maintained remotely using the Node Management System software on a local PC through the
network using the ACS and SNMP servers.
4. Installation Procedure
This section covers how to install a Pandora and make initial installation test before taking the
node into operation.
NOTE: All cables used should be shielded.
4.1. Tools for Installation
The following tools are required to safely and correctly install a Pandora node.
Required:
Power Tool with 10 mm socket (capable of a defined torque)
Screwdriver (Philips Ph2)
In case of installation with -48V
Cutting Plier
Crimping Plier
Knife
4.2. Unpacking