User Guide

5
Faulty and damaged products/Service
• If user suspects damage or identifies signs of overheating, stop use and return product to a
service center for inspection.
• If the product is exposed to liquid or excessive heat, or does not operate normally when you
follow the operating instruction, stop use and return product to a service center for inspection.
• Do not attempt to disassemble or service the product or its accessories.
• Only qualified personnel must service or repair the product or its accessories.
• Do not use a damaged product as personal injury or further damage may result.
Cleaning the product
Remove the battery and/or unplug the product from its power source before cleaning. Use a soft damp
cloth for cleaning, but NEVER immerse the product in water or cleaning solutions. Do not use harsh
chemicals, cleaning solvents, liquid cleansers or aerosols to clean the product or its accessories.
Prevention of hearing loss
CAUTION:
Permanent hearing loss may occur if product’s headset is used at high volume for
prolonged periods of time. Your product is configured to assist with prevention of hearing
damage through the use of warning messages
when the volume is set over a threshold for an extended period of time.
This device has been tested to comply with the Sound Pressure Level requirement laid
down in the applicable EN 50332-1 and/or EN 50332-2 standards.
About Headset regulatory agency identifications
For regulatory identification purposes, VIVE headset product is assigned a model number of
2QA4100. Headset FCC ID is NM82QA4100. This FCC/IC ID can also be found as below process: Setting
→ About → Regulatory information
To ensure continued reliable and safe operation of headset, use only the following accessory with
your 2QA4100:
- Battery Pack with a model number of B028QK100.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 12 Volts
DC, 2.5 Amp power supply unit.
About Controller regulatory agency identifications
For regulatory identification purposes, VIVE controller product is assigned a model number of
2Q8R100 / 2Q8R200. controller FCC ID is NM82Q8R100 / NM82Q8R200. This FCC/IC ID can also be
found on the controller itself
To ensure continued reliable and safe operation of your controller, use only the following accessory
with your 2Q8R100 / 2Q8R200:
Battery Pack with a model number of B0PLH100.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts
DC, 1 Amp power supply unit.
About Battery Pack Regulatory agency identifications
For regulatory identification purposes, the Battery Pack has been assigned a model number of
Headset : B028QK100；Controller: B0PLH100
THE BATTERY IS NOT FULLY CHARGED WHEN YOU TAKE THE DEVICE OUT OF THE BOX.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.