User Guide

4
cleaning solutions. Do not use harsh chemicals, cleaning solvents, liquid cleansers or aerosols to clean the product or its accessories.
Prevention of hearing loss
CAUTION: Permanent hearing loss may occur if product’s headset is used at high volume for prolonged periods of time. This device
has have been tested to comply with the Sound Pressure Level requirement laid down in the applicable EN 50332-1 and/or EN
50332-2 standards.
Regulatory agency identifications
For regulatory identification purposes, your product headset is assigned a model number of 2Q9R100.
Your product’s FCC ID is NM82Q9R100. This FCC ID can also be found printed on the product.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your 2Q9R100:
 Battery Pack with model number B2PXH100.
 Certified Limited Power Source (LPS), [rated 5 Volts DC, minimum 2.5 Amp power supply unit or rated 9 Volts DC, minimum 1.7 Amp power
supply unit].
For regulatory identification purposes, your controller is assigned a model number of IHM100.
Your controller’s FCC ID is NM8IHM100. This FCC ID can also be found printed on the product.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your IHM100:
 Certified Limited Power Source (LPS), [rated 5 Volts DC, minimum 0.5 Amp power supply unit or USB port of power supply.].
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Innovation, Science and Economic Canada Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Canada’s license-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not
intended to prohibit transmission of control or signaling information or the use of repetitive codes where required by the technology.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile
satellite systems.
European Union Notice
HTC declares that the device complies with the essential requirements and relevant provisions of the Radio Equipment Directive
(2014/53/EU) issued by the Commission of the European Community. For more information including a full copy of the Declaration
of Conformity certificate please visit http://www.vive.com/doc.
This radio equipment operates with the following frequency bands and maximum radio-frequency power:
Maximum Tune-up Conducted Power (dBm)
Headset
Bluetooth: 6.4
BLE: 1.9
802.11 b: 18
802.11 g: 16.4
802.11 n HT20 (2.4GHz): 19.5
802.11 n HT40 (2.4GHz): 18.8
802.11 n VHT20 (2.4GHz): 19.4
802.11 n VHT40 (2.4GHz): 18.7
802.11 a: 17
802.11 n HT20 (5GHz): 19.91
802.11 n HT40 (5GHz): 19.57
802.11 n VHT20 (5GHz): 19.81
802.11 n VHT40 (5GHz): 19.47
802.11 n VHT80 (5GHz): 19.91
2.4G 3.4
Controller
2.4G: 4
The operation of 5.15-5.35GHz is restricted to indoor use in all EU Member States.
AT BE BG HR CY CZ DK
EE
FI
FR
DE
EL
HU
IE
IT
LV
LT
LU
MT
NL
PL
PT
RO
SK
SI
ES
SE
UK
Radio Frequency exposure
This product meets the U.S. Federal Communications Commission's (FCC) requirements for exposure to radio waves and is designed and
manufactured not to exceed the FCC's emission limits for exposure to radiofrequency (RF) energy. This product and its antenna(s) must not be
co-located or operating in conjunction with any other antenna or transmitter.
Body-worn Operation