User Guide

turning on power.
General precautions
• Use only accessories approved for use with the product. Do not connect with incompatible products or accessories.
• Protect the product. Always treat the product and its accessories with care.
• Do not use near a heater, fireplace, direct sunlight, air conditioning unit or other source of direct energy.
• Do not expose product to liquid.
• Do not use the product in any potentially explosive atmosphere or where flammable materials exist.
• Do not attempt to open, take apart or otherwise disassemble this product or its accessories.
• Keep product in a clean and dust-free place.
• Do not expose the product or its accessories to open flames or lit smoking products.
• Do not drop, throw or bend the product or its accessories.
• Do not paint or apply any coating to the product or its accessories.
• Store the product and its accessories at temperatures between 0°C to 40°C
• Avoid dropping the product headset or controllers. If dropped, especially on a hard surface, and the user
suspects damage, take it to a service center for inspection.
• Please check local regulations for disposal of electronic products
• Never push objects of any kind into slots or other openings in the product. Slots and openings may be provided for ventilation.
These openings must not be blocked or covered.
• If the product becomes uncomfortably warm during use, stop and allow it to cool down before continued use to avoid discomfort,
redness, or low temperature burns.
• If there is any itching, eczema, swelling, irritation of the skin, or you experience any discomfort, please discontinue
use and consult your physician.
Faulty and damaged products/Service
• If user suspects damage or identifies signs of overheating, stop use and return product to a service center for inspection.
• If the product is exposed to liquid or excessive heat or does not operate normally when you follow the operating instruction,
stop use and return product to a service center for inspection.
• Do not attempt to disassemble or service the product or its accessories. Only qualified personnel must service or repair the
product or its accessories.
• Do not use a damaged product as personal injury or further damage may result.
Cleaning the product
• Unplug the product from its power source before cleaning. Use a soft damp cloth for cleaning, but NEVER immerse the
product in water or cleaning solutions. Do not use harsh chemicals, cleaning solvents, liquid cleansers or aerosols to clean
the product or its accessories.
Prevention of hearing loss
CAUTION: Permanent hearing loss may occur if headset earphones are used at high volume for prolonged
periods of time.
Turn down the volume before using headphones or other audio devices.
About headset regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of 2Q2R100.
Your product’s FCC ID is NM82Q2R100. This FCC ID can also be found printed on the headset.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your 2Q2R100.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 12 Volts DC, maximum 2.5
Amp power supply unit.
About controller regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of 2Q3Z100/2Q3Z200.
Your product’s FCC ID is NM82Q3Z100/NM82Q3Z200. This FCC ID can also be found printed on the controller.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your
2Q3Z100/2Q3Z200.
NOTE: This product is intended for use with AA Alkaline batteries (2 for each device).
About link box regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of 2Q2B200.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your 2Q2B200.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 12 Volts DC, maximum 2.5
Amp power supply unit.
Radio Frequency exposure
For body worn operation, this device has been tested and meets FCC and ISED RF exposure guidelines when used with
an accessory that contains no metal. Use of other accessories may not ensure compliance with FCC and ISED RF
exposure guidelines.
To comply with the FCC and ISED RF exposure compliance requirements, this device and its antenna must not be co-
located or operating in conjunction with any other antenna or transmitter.
Déclaration de l'exposition aux radiations RF:
Pour une utilisation sur le corps, cet appareil a été testé et respecte les directives sur l'exposition aux RF lorsqu'il est utilisé avec un
accessoire sans métal. L'utilisation d'autres accessoires peut ne pas garantir la conformité aux directives d'exposition aux RF.