User Guide

supply unit.
For body worn operation, this device has been tested and meets FCC and ISED RF exposure guidelines when used with an accessory
that contains no metal. Use of other accessories may not ensure compliance with FCC and ISED RF exposure guidelines.
To comply with the FCC and ISED RF exposure compliance requirements, this device and its antenna must not be co-located or
operating in conjunction with any other antenna or transmitter.
Déclaration de l'exposition aux radiations RF:
Pour une utilisation sur le corps, cet appareil a été testé et respecte les directives sur l'exposition aux RF lorsqu'il est utilisé avec
un accessoire sans métal. L'utilisation d'autres accessoires peut ne pas garantir la conformité aux directives d'exposition aux RF.
About VIVE controller regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of 2PR7200.
Your product’s FCC ID is NM82PR7200. This FCC ID can also be found printed on the VIVE controller.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your 2PR7200:
The Battery Pack has been assigned a model number of B0PLH100.
THE BATTERY IS NOT FULLY CHARGED WHEN YOU TAKE THE DEVICE OUT OF THE BOX.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 5 Volts DC, maximum 1 Amp power
supply unit.
RF exposure:
For body worn operation, this device has been tested and meets FCC RF exposure guidelines when used with an accessory that
contains no metal and that positions the device a minimum of 5 mm from the body. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines.
To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-located or operating in
conjunction with any other antenna or transmitter.
About Link box regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of 2Q2B100.
Your product’s FCC ID is NM82Q2B100. This FCC ID can also be found printed on the Link box.
To ensure continued reliable and safe operation of your device, use only the accessories listed below with your 2Q2B100:
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 12 Volts DC, maximum 1.5 Amp power
supply unit.
FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with a minimum distance of 20 cm between the radiator and your body.
ISED RF Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20 cm between the radiator & your body. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
European Union notice
HTC declares that the device complies with the essential requirements and relevant provisions of Directive (2014/53/EU). For more
information including a full copy of Declaration of Conformity certificate please visit : http://www.vive.com/doc
This device complies with Directive 2014/53/EU issued by the Commission of the European Community.
The radio equipment operates with the following frequency bands and maximum radio frequency power :