User's Handbook

™
Page 60 of 66
5 The Loc3 Series Transmitters
In SD mode
Volume
LCD Contrast
Receiver Link Disabled
Frequency Menu
About
5 and 10-Watt Transmitters
Volume
Voltage
Resistance
LCD Contrast
Receiver Link Disabled
Frequency Menu
About
25-Watt Transmitter
In Clamp mode
Volume
Voltage
LCD Contrast
Receiver Link Disabled
Frequency Menu
About
5 and 10-Watt Transmitters
Volume
Voltage
Resistance
LCD Contrast
Receiver Link Disabled
Frequency Menu
About
25-Watt Transmitter
2. The screen will show a list of
frequencies available, with the
central one in a box
Frequency Menu
SD-USA X
FF Low
FF High
5 and 10-Watt Transmitters
Frequency Menu
4Hz/8Hz/98Hz X
4Hz/8Hz/128Hz
3Hz/6Hz/512Hz
25-Watt Transmitter
3. Pressing the “+” or “-” pushbuttons, you can scroll up or down through the available frequencies.
4. Once the wanted frequency
is inside the box, press the “f”
pushbutton to select or deselect
the frequency. An “x” will appear in
the box for a selected frequency.
Frequency Menu
SD-USA
FF Low X
FF High
5 and 10-Watt Transmitters
Frequency Menu
4Hz/8Hz/98Hz X
4Hz/8Hz/128Hz X
3Hz/6Hz/512Hz
25-Watt Transmitter
5. After selecting the frequencies press the “i” pushbutton again to exit the “Frequency Menu” and return to the main display.
6. A particular frequency in the chosen list of frequencies can be selected from the screen by pressing the “f” pushbutton until
the wanted frequency is displayed at the top of the main screen.
5.8.3 Multi-Frequency Mode for Direct Connection
This feature can be used to energize two or three frequencies simultaneously on the target line. This is especially helpful when
the user is unsure which frequency is best to apply to the target line.
NOTE
• When using the multi-frequency mode total power will be split between the activated frequencies.
• The multi-frequency mode is not available in Fault Find and SD modes.
• The frequencies have to be available in the main menu.