User's Handbook

™
Page 37 of 66
3 Using the vLoc3 RTK-Pro
3.10.2 Performing an RTK-Pro Walk Back
Now that the Walk Back points have been selected, the VMMap cloud uses the RTK-Pro receiver containing the assigned
receiver serial number and Walk Back points.
1. In the RTK-Pro menu, navigate to scroll to Walk Back and enter the sub-menu option.
Menu
GPS RTK Source
Tilt log
New Survey
Log Feature
Auto Log Features
Walk Back
Regulatory Labels
Always
Enabled
Walk Back
Get list
Cloud status Up to date
2. At the Get list option and press the enter pushbutton to bring up the list of Walk Back points allocated to this receiver's
serial number from the VMMap Cloud.
3. Once the Walk Back points have been downloaded from the VMMap Cloud, they
are displayed in a list by the Walk Back point description.
Scroll to the point needed to Walk Back to and click on the enter pushbutton.
4. Once the Walk Back point is selected a screen similar to the one shown on the
right will be seen.
Walk Back
Get list
Walk Back Point 1
Walk Back Point 2
Walk Back Point 3
On this screen the following is displayed:
• Shows your current Latitude, Longitude and Altitude and horizontal accuracy in
2DRMS.
• Shows the horizontal distance from the locator GNSS antenna to the Walk Back
point in the bottom right corner of the screen.
• When further from the Walk Back point and moving a guidance arrow points
towards the Walk Back point.
4G
50°57′32.1037′′N
3°52′29.1374′′W
564′2′′
0′1′′ (2DRMS)
15′0′′
Note:
• The Guidance arrow assumes you are holding the locator in front of you, with the bottom of the screen
closest to you.
• When stationary, no guidance arrow is shown.