User guide

Troubleshooting
Problem Cause Action
No Picture or Sound The Transmitter and receiver
are set to different channels
Set to identical channels (See step 10)
The Transmitter and/or
Receiver are not powered
Check the power switch on the unit(s) are
in the On position
Check that the Mains Electrical power is
switched on
Check the Mains adaptors are fitted
correctly (See Steps 3 & 9)
The Transmitter and/or
Receiver Leads are incorrectly
fitted/reversed
Swap over both leads so the correct leads
are used with the Receiver/Transmitter
The leads are not inserted correctly, ensure
that the scart plug has no bent pins and it
making contact with the scart socket
Transmitter and/or Receiver
Units are reversed
Swap over the Transmitter and Receiver
units
The equipment providing or
receiving the AV signal are
incorrectly setup
Check that the Transmitting and Receiving
Equipment are powered up and providing
a Scart Input and output signal
Ensure that correct Scart input has been
selected on the Receiving equipment
Set the Scart output/input to Composite
Video (CVBS) (See Equipment Suppliers
Manual for how to set)
Distance between the Trans-
mitter and receiver is too far
Reduce the distance between the units or
position the units for a better signal
Black and White
(Monochrome
Picture)
The equipment providing or
receiving the AV signal are
set to RGB, Component Video,
SVHS S Video, DVI or HDMI
Set the Scart output/input to Composite
Video (CVBS) (See Equipment Suppliers
Manual for how to set)
Poor Picture Quality Interference from microwaves
ovens.
Move Transmitter/Receiver away from
microwave.
Obstruction to signal Place away from walk ways or walk through
areas
Place away from Thick walls, masonry or
metalwork
Distance between the Trans-
mitter and receiver is too far
Reduce the distance between the units or
position the units for a better signal
The Transmitter and receiver
are set to different channels
Set to identical channels (See step 10)
The equipment providing or
receiving the AV signal are
incorrectly set
The Leads are not inserted correctly, ensure
that there are no bent pins in the scart plug
and it making contact
PROBLEM CAUSE ACTION
Page 6