Fridge DW Series Product Manual
A
B
Fig. 6.1.2.1
6.1.2 - “FINE” ADJUSTMENT FOR WATER SUPPLY (version with
ice maker)
To access the screw to adjust the incoming water level, remove the plastic casing from the ice maker
(Fig. 13, A).
Use a screwdriver on the water level adjustment screw (Fig. 13, b) to move the contact directly
on the grid assembly.
- Turn the screw clockwise: to reduce the amount of water
- Turn the screw anticlockwise: to increase the amount of water
A full turn (360°) will increase/reduce water by 40 cm³ (~2.4 sec.)
A half turn (180°) will increase/reduce water by 20 cm³ (~1.2 sec.)
PLEASE NOTE:
After it has been installed, the Ice Maker will run an empty cycle and then
produce ice during all subsequent cycles.
The rst cubes will be dispensed after approximately 1 hour.
A4
R
V
I
F
I
T
R
O
I
G
6.2 - ICE MAKING MODE (version with ice maker)
- Production
The base of the grid assembly is lled with water and the thermostat re-
mains in the open position.
Once the set temperature has been reached, the cycle for ice ejection from
the grid assembly (J) (~ 40 min.) will begin.
- Ejection
1
Once at the correct temperature, the thermostat will close, starting the
heating element and the motor.
2
Extractor blades will press down on the ice to remove it;
the heating element remains on
3
The blades extract the ice cubes from their seating, pouring them into
the rack. The ice-making cycle will continue until the ice hopper is full
68
EN