Instruction manual

18
6.14 CAMERA ID menu
Up to 40 characters can be input for camera ID.
To enter CAMERA ID menu, press ● button at MAIN menu-2>CAMERA ID.
Use ▲,▼,◀,▶ buttons to move a block cursor over the character table and press ● button to input the
selected character.
To move the character input position on CAMERA ID input line, move a cursor to ←→ on COMMAND
LINE and press ● button on ← or →.
To clear CAMERA ID input line, move a cursor to CLR on COMMAND LINE and press ● button.
To set the location of CAM TITLE to be displayed on the monitor, move a cursor to POS and press ●
button
and then menu disappears and CAMERA ID will be displayed on the monitor.
Move CAMERA ID by using ▲,▼,◀,▶ buttons and press ● button to fix.
Menu will appear again.
To finish CAM TITLE menu, press ● button on RET on command line.
6.15 CAMERA RESET
Camera loads Factory defaults.
To save them, go to SAVE ALL and press ● button.
6.16 EXIT
Exits SETUP MENU and returns to the normal display
COMMAND LINE
CAMERA ID input line