Specifications

Verifact L-DT
•Two Opposing Built-In Mircophones
•Low Impedance, Omni-Directional Pattern
•Contains Pre-Amp For Line Level Output
•ABS Housing For Long Endurance
•May Be Located Up To 1,000ft. From Base
Station
•Weighted, Non-Slip Bottom For Firm
Adherance To Desktop or Any Flat
Horizontal Surface.
Verifact B
•Low Impedance
•Electret Condenser Microphone With
Built-In Preamp For Producing Line Level
Output.
•Housed In A High Impact ABS Dome
Designed For High Ceiling Applications.
•Normal Pick-Up Pattern Is Approximately
15’ From The Microphone Location, All
Directions, or Within 30’ Diameter Circle.
•An Extension Cable For Mounting The
Microphone From 3 To 10 Feet From It’s
Housing.
•Compatible With All Louroe Base Stations.
Verifact DVR
•Designed For Correctional Facilities
•High Sensitivity To Low Sound Pressure
•Pick Up Normal Sounds 15’ Away
•16 Gauge Stainless Steel Faceplate
•Hooded Audio Port
•Recessed Housing For Mic’ Protection
•Tamper Proof Mounting Screws
•Can Locate Up To 1000’ From Base Station
•Phantom Powered
•Microphone Preamp Contains Sensitivity
Switch For Lowering Gain
•Fits Into Single Gang Electrical Box
Verifact E
•High Sensitivity To Low Sound Pressure
•Omni-Directional, Picks Up Normal Sounds
15ft. Away
•May Be Located Up To 1,000ft. From The
Base Station
•Phantom Powered From Louroe Base
Station
•Weather Resistant For Outdoor Use
•Surface Mount Only
•Preamp Contains A Sensitivity Switch For
Lowering Gain
Undirectional Preamplified Microphone For
Use Where Background Noise Must Be
Reduced.
•Reduced (20db) Sensitivity On All Sides.
•Unique Dual Electret Pickup and Differential
Amplifier
•Low Noise MOSFET
•Adjustable Gain.
•Line Level Unbalanced Output.
•Limiter and TB Circuits Selectable On/Off.
•12VDC @ 10mA.
•On-Board Voltage Regulator
Omni-Directional Microphone Standard
Omni-Directional Preamplified Microphone
Mounted On A Stainless Steel Single Gang
Plate. 25’ Range In All Directions. Selectable
On / Off Treble Boost Circuit Enhances
Time-Lapse Recordings. Flush or Surface
Mountable.
•Low Noise MOSFET Preamplifier.
•Adjustable gain.
•Line Level Unbalanced Output.
•Limiter Circuits Selectable On/Off.
•Easy Cable Run Termination.
•Power: 12VDC @ 10mA.
•On-Board Voltage Regulator
•Optional Surface Mount Adapter, SM1-S
Weather Resistant Omni-Directional Pre-
amplified Microphone. Selectable On / Off
Treble Boost Circuit Enhances Time-Lapse
Recordings. Mounts On Single Gang Bell
Box, Gasket Included.
•Low Noise MOSFET Preamplifier.
•Adjustable gain.
•Line Level Unbalanced Output.
•Limiter Circuits Selectable On/Off.
•Power: 12VDC @ 10mA.
•On-Board Voltage Regulator
•Optional Surface Mount Adapter, SM1-SW
Tabletop Microphone. An Omni-Directional
Microphone Designed To Sit On A Table
Top. Built-In Weight and 4 Rubber Feet Help
Minimize Unwanted Movement.
•Low Noise MOSFET Preamplifier.
•Adjustable gain.
•Line Level Unbalanced Output.
•Limiter and TB Circuits Selectable On/Off.
•Easy Cable Run Termination.
•12VDC @ 10mA.
Standard Omni-Directional
Preamplified Microphone.
•25’ Range In All Directions.
•Selectable On/Off Treble Boost Circuit
Enhances Time-Lapse Recordings
•Low Noise MOSFET Preamplifier.
•Adjustable gain.
•Line Level Unbalanced Output.
•Limiter Circuits Selectable On/Off.
•Power: 12VDC @ 10mA.
•On-Board Voltage Regulator
•Optional Surface Mount Adapter SM1-S
Remote Element Mircophone.
Omni-Directional Preamplified Microphone.
•Low Noise MOSFET Preamplifier.
•Adjustable gain.
•Line Level Unbalanced Output.
•Limiter and TB Circuits Selectable On/Off.
•Easy Cable Run Termination.
•Power: 12VDC @ 10mA.
•On-Board Voltage Regulator
•Mounting Grommet.
Replacement For Surface Mount Adapter
Standard Omni-Directional Preamplified
Microphone; 25 Foot Range In All Directions.
Selectable On/Off Treble Boost Circuit En-
hances Time-Lapse Recordings. For Surface
Mount Applications Only.
•Low Noise MOSFET Preamplifier.
•Adjustable gain.
•Line Level Unbalanced Output.
•Limiter Circuits Selectable On/Off.
•Easy Cable Run Termination.
•Power: 12VDC @ 10mA.
•On-Board Voltage Regulator
•Dimensions (Excluding Mounting Tabs):
L 3.8” x W 2.7” x H 1.25”
Omni-Directional Preamplified Microphone
and Speaker For Use In Two Way
Surveillance Systems. Optional Call Switch
(Not Shown) For Paging Listener. Stainless
Steel Cover. Fits Double Gang Boxes.
•Low Noise MOSFET Preamplifier.
•Adjustable gain.
•Line Level Unbalanced Output.
•Limiter and TB Circuits Selectable On/Off.
•2.25” Speaker. 0.5 Watt RMS.
•Built-In ETS LT870 70V Line Transformer.
•Power: 12VDC @ 10mA.
•On-Board Voltage Regulator
STW1-C Optional Call Switch
STW1-2 2-Way Outdoor Microphone /
Speaker; Stainless Steel
STW1-2C 2-Way Outdoor Microphone
/ Speaker With Call Switch
STW1-S Surface Mount Adapter
Microphones
37
call: 877.801.5511 | fax: [phone]
Microphones