User manual

ENVI Series IP Configuration Manual

________________________________________________________________________________

3. System Operation

1. Remote Video Monitoring

There are two ways to monitor video when the decoder site and the ENVI IP2 Camera are connected.

For proper operation, an IP address must be set accordingly. Please refer to ENVI VMS in Chapter 3 or

Remote Setting in Chapter 4 for further details.

Default ID: admin

Default Password: 1234

 Video Monitoring with Decoder System

Once the ENVI IP2 Camera‟s IP address is set in the remote IP address section of the decoder, the

decoder system will connect to the ENVI IP2 Camera and start receiving the video images. Normally, a

monitor connected to the decoder will display video images.

 Video Monitoring using Internet Explorer

Open Internet Explorer and enter your ENVI IP2 Camera‟s IP address. The system will ask for

confirmation to install Active-X control. Once authorized, Internet Explorer will start to display video

images from the ENVI IP2 Camera as shown below.

Default IP Address: http://192.168.10.100