User manual

ENVI Series IP Configuration Manual
________________________________________________________________________________
29
The ENVI IP2 Camera has one sensor port and one alarm port.
When a decoder system, instead of a PC client, is connected to an ENVI IP2 Camera, one system
becomes a Local system and the other a Remote system. (Generally a system that is being used by the
user is called as Local system). Then, actions for events can be configured for events from the remote
system as well as for local system. For example, it is possible to turn on an alarm device in local (center)
decoder system when a sensor device in remote (site) IP camera is triggered. Local section configures
the actions for events from local (self) systems, and configuration activates local devices and Remote
sections configure the actions for events from remote (peer) system.
The following table lists the possible actions for events.
Action
Description
Sensor In
One sensor in port
Alarm out
Triggers alarm (relay) port.
E-mail
Sends E-mail to the specified address. AVI
file can be attached.
FTP
Upload AVI file to a specified FTP server.
 Local & Remote Event Configuration
 The Sensor1 / Sensor2/ Sensor3 / Sensor4.
Configure the actions when the sensor is activated. Multiple actions can be set for a single
event.
 On Video Loss
Configure the actions when video input signal is lost. Multiple actions can be set for a single
event.
 On Motion
Configure the actions when motion is detected. Multiple actions can be set for a single event.
 On Disconnect
Configure the actions when the link (connection) with peer a system is disconnected. Multiple
actions can be set for a single event.