VTC-C2BMS2 Premium 2.1 Megapixel 6-in-1 HD/ EX-SDI / TVI / AHD / CVI / CVBS Box Type Camera VITEK VITEK FEATURES: • 1/2.8” Sony® STARVIS 2.1 MegaPixel CMOS Sensor • 2.1 MegaPixel with Full 1080p/720p HD/EX-SDI 1.0, 2.
Safety Precaution To prevent fire or shock hazard, do not expose the unit to rain or moisture. To prevent electric shocks and risk of fire hazards, do NOT use other than specific power source. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Safety Precaution NOTICE The image used in this instruction manual are processed to help comprehension and may differ from actual video of the camera. Avoid installing areas where has shock or vibration which results in the problems. Pay attention to safety when running the connection cable and observe that the cable is not subjected to heavy loads, kinks or damage and no moisture can get in. The warranty becomes void if repairs are undertaken by unauthorized persons.
Contents p.02~03 Safety Precaution p.04 Contents p.05 Composition p.05 Dimensions p.06~07 Installation Instructions p.08~23 Operating Instructions p.
Composition Dust Protection Cap (1pc) Box Camera Torque Wrench: 3mm (1pc) C-mount adaptor (Option) Operating Instruction 1.38” 2.83” Dimensions 2.99” 3.50” 2.
Part Names Mount Holes (Top / Bottom) Dust Protection Cap E ID Body Case EW VI Torque Wrench S PIN 4 PIN 3 PIN 2 PIN 1 Lens Connector for Auto Iris lenses DC Iris Damp(-) Damp(+) Drive(+) GND No.
Installation Instructions Installation and commissioning Instructions • Make sure power is removed before installation. • Follow this order for powering camera: Connect the power leads to the camera (observe polarity for DC power) then plug-in power. This will avoid damage to the camera from power surges and improper reseting 1. Remove the dust protection cap from the lens mount. 2. Screw the lens onto the camera firmly. 3. Plug the lens plug into the lens connector on the side of camera case. 4.
Operating Instructions Power Supply Connections Camera can work with either 12VDC or 24VAC, dual voltage power. Primary and secondary grounds are completely isolated to avoid possible ground-loop problems. Using OSD Controller Setup menu can be accessed and controlled by the OSD control joystick on the rear of the camera unit. Five commands are available with the joystick. The design of the OSD could be different according to the Model.
Operating Instructions ANALOG OUT0 should be set to TVI MODE, AHD MODE or CVI MODE to get CVBS video in sub-out. If it is set to CVBS, there is no CVBS video in sub-out port. (SYSTEM> OUTPUT> ANALOG OUTPUT0) If CVBS video is enabled through ANALOG OUT or Sub-out port, WDR and 3D-NR functions are disabled in all video outputs. It should be considered when installer adjusts the video with installation monitor via CVBS video signal.
Operating Instructions 3D-NR OFF, LOW, MIDDLE, HIGH IMAGE SHARPNESS MAIN OUTPUT ANALOG ANALOG OUT0 TVI MODE, AHD MODE, OUT0 CVBS, CVI MODE TVI MODE 0~10 AHD MODE 0~10 CVI MODE 0~10 ANALOG ANALOG OUT1 CVBS OUT1 SDI&CVBS 0~10 SDI SDI OUT OUTPUT SDI&CVBS GAMMA HD-SDI, EX-SDI 1.0, EX-SDI 2.0, OFF 0~10 0.45, 0.55, 0.65, 0.
Operating Instructions OSD menu Startup Press the ‘OSD menu SET key’ down to access the setup menu mode. • EXIT : Enters ‘EXIT’ menu with save current setting or without save. • RETURN : Returns to the previous menu. MENU V0. XX 1. LENS 2. FOCUS Ast. 3. EXPOSURE 4. BACKLIGHT 5. DAY&NIGHT 6. COLOR 7. 3D-NR 8. IMAGE 9. MOTION A. SYSTEM B. EXIT DC OFF OFF AUTO MIDDLE OFF SAVE 1. LENS Lens can be selected either DC or MANUAL lens. It should be selected according to lens type. 1-1.
Operating Instructions 3. EXPOSURE 3. EXPOSURE BRIGHTNESS SHUTTER SENS-UP AGC RETURN 9 llllllllllllllllllllll AUTO X2 7 llllllllllllllllllllll 3-1. BRIGHTNESS Adjusts the brightness of video (0~20). 3-2. SHUTTER Select AUTO or MANUAL. If shutter is set to Manual mode, SENS-UP mode is deactivated. 3-2-1. AUTO: Optimizes the video level by controlling the iris and the shutter speed automatically. 3-2-2.
Operating Instructions 4. BACKLIGHT Compensates the video image by cutting out the bright areas with a mask or adjusting the contrast of the video. HLC LEVEL COLOR RETURN 10 llllllllllllllllllllll BLK 4-1. HLC (High Light Compensation) Cuts out the bright area with a mask and excludes it from compensation. 4-1-1. LEVEL (0~20): Sets the HLC level. It determines the video level that starts cutting out. Lower setting starts the cut out at a lower light level. The cut out area is masked with selected color.
Operating Instructions ROI WDR WINDOW ZONE 0 WINDOW USE ON H-POS 469 V-POS 194 H-SIZE 739 V-SIZE 688 RETURN MODE ROI TARGET-BRT MIDDLE WEIGHT MIDDLE RETURN 4-3. WDR (Wide Dynamic Range) When part of an image is extremely dark but another part is so bright you can't see any details WDR will even the image out. 4-3-1. MODE : Selects WDR mode normal or ROI setting. • NORMAL: WDR function applies full screen. • ROI (Region Of Interest) : Sets specific area of WDR by window setting.
Operating Instructions 5. DAY & NIGHT DAY/NIGHT is used to control the setting during day-time and night-time operation. Select the mode according to the light condition and the camera types. MENU V0. XX 1. LENS 2. FOCUS Ast. 3. EXPOSURE 4. BACKLIGHT 5. DAY&NIGHT 6. COLOR 7. 3D-NR 8. IMAGE 9. MOTION A. SYSTEM B. EXIT DC OFF OFF AUTO MIDDLE OFF SAVE 5-1. EXTERN DAY or NIGHT is determined by the built-in light photo sensor for cameras with built-in IR LEDS. 5-1-1.
Operating Instructions 5-2. AUTO Used when DAY or NIGHT is determined by light level through the lens and DAY from/to NIGHT is switched automatically by the scene brightness. It can be controlled by the AGC threshold level, AGC margin and delay time. 5. DAY&NIGHT SMART IR ANTI-SAT. AGC THRES AGC MARGIN DELAY RETURN OFF 10 llllllllllllllllllllll 10 llllllllllllllllllllll 10 llllllllllllllllllllll MIDDLE 5-2-1.
Operating Instructions 6. COLOR 6. COLOR AWB COLOR GAIN RETURN AUTO 10 llllllllllllllllllllll 6-1. AWB (Auto White Balance) Automatically tracks the changes of color temperature and continuously adjusts the white balance. AUTO, AUTOext, PRESET and MANUAL modes are available. 6-1-1. AUTO : Optimized for Indoor installation and compensates AWB for low color temperature such as incandescent lights. 6-1-2.
Operating Instructions 7. 3D-NR (Digital Noise Reduction) DNR function improves picture quality by filtering out signal noise which is generated under low light conditions. Set off, low, middle or high level. 3DNR(3-dimensional noise reduction) which reduces noise by multi frames. It is effective in low light. Set to high will reduce the most noise but the image will be less sharp and a tailing effect might occur. MENU V0. XX 1. LENS 2. FOCUS Ast. 3. EXPOSURE 4. BACKLIGHT 5. DAY&NIGHT 6. COLOR 7. 3D-NR 8.
Operating Instructions 8-1. SHARPNESS Sets the Sharpness level 0~10. Increases or decreases the sharpness of the picture. Too much sharpness can make image harsh and show more noise as well as line flicker at the edge of object in the picture. 8-2. GAMMA Adjust gamma level of video. 8-3. MIRROR The Video is reversed left and right if turned ON. 8-4. FLIP The Video is reversed upside down if turned ON. When the video is fliped Vertical, then the joystick directions are reversed accordingly.
Operating Instructions PRIVACY ZONE NUM ZONE DISP H-POS V-POS H-SIZE V-SIZE Y-LEVEL CB LEVEL CR LEVEL TRANS RETURN 0 ON 12 2 3 3 10 llllllllllllllllllllll 10 llllllllllllllllllllll 10 llllllllllllllllllllll 0 8-7-4. H-SIZE, V-SIZE : Adjusts the mask size using H, V direction. 8-7-5. Y LEVEL : Adjusts the mask color by Y LEVEL. (0: black ~ 20: white) 8-7-6. CB LEVEL : Adjusts the mask color by CB LEVEL. (0: yellow ~20: blue) 8-7-7. CR LEVEL : Adjusts the mask color by CR LEVEL.
Operating Instructions 9. MOTION DET WINDOW DET TONE MDRECT FILL SENSITIVITY MOTION OSD TEXT ALARM RETURN DET WINDOW WINDOW ZONE WINDOW USE DET H-POS DET V-POS DET H-SIZE DET V-SIZE RETURN 2 ON 5 llllllllllllllllllllll OFF OFF 0 ON 1 1 58 32 9-2. DET ZONE Sets the detection zone 0 to 4 display types which window use setting ON. 0 : Set 100% opacity level of video background except detection window zone. 1 : Set 50% opacity level of video background except detection window zone.
Operating Instructions A. SYSTEM Sets the system related functions. A.
Operating Instructions If CVBS video is enabled through ANALOG OUT or Sub-out port, WDR and 3D-NR functions are disabled in all video outputs. It should be considered when installer adjusts the video with installation monitor via CVBS video signal. A-2. RESOLUTION Select the video resolutions, 1080P/720P are available. 1080P outputs 1920x1080 video at the frame rate of 30P/25P. 720P outputs 1280x720 video at the frame rate of 60P/50P. A-3.
VTC-C2BMS2 Premium 2.1 Megapixel 6-in-1 HD/EX-SDI / TVI / AHD / CVI / CVBS Box Type Camera Detailed Specifications Imaging Sensor 1/2.8” Sony® STARVIS 2.1 MegaPixel CMOS Sensor Effective Pixels 1920(H) x 1080(V) x 30p Scan Frequency 30Hz(V), 22.5Khz(H) / Progressive Video Format HD: 16:9, 1080p@30fps / CVBS: 16:9 (NTSC) Video Output HD/EX-SDI 1.0, 2.0 / TVI / AHD / CVI / CVBS Video Resolution 2.1 MegaPixel 1080p (1920x1080) Min.Illumination Color: 0.08 Lux, B/W: 0.
CONSIDER THESE OTHER GREAT PRODUCTS FROM OnCue Bridge 8 & 16 Channel Complete HD/EX-SDI, TVI, AHD, CVI, Analog & IP Recording Solution 8 & 16 Channel Stand-alone Real-time Video Recorders • Supports IP, HD/EX-SDI, TVI, AHD, CVI, Analog (CVBS) Cameras with automatic format detection • Full HD MegaPixel Real-time recording, live display, and playback • Panorama (Thumbnail) Search • HDMI 2.
LIMITED PRODUCT WARRANTY VITEK products carry a three (3) year limited warranty. Digital recording and storage products are also warranted for 3 years. * Per a special agreement with Western Digital, as of August 2016, VITEK also warrants factory installed Hard Drives for the full 3 year span of the recorder warranty provided that the recorder was purchased through an authorized VITEK distributor.
Version 1.0 28492 CONSTELLATION ROAD VALENCIA, CA 91355 September 2017 WWW.VITEKCCTV.
